Porcelain and composite cross‑arm insulators feature an integral long‑rod structure: one end is fixed to the utility pole, while the other end directly supports the conductors, providing both cross‑arm support and electrical insulation. They are primarily used on 6 kV and 10 kV rural branch circuits and compact distribution lines in mountainous areas, helping to reduce steel consumption, minimize wind resistance, and enhance lightning protection. However, their flexural strength is relatively limited, so careful selection is required for applications involving large turning angles or heavy ice loads.
25
2026
/
06
Butterfly insulators have a butterfly‑shaped profile and cannot independently support long overhead conductors. Their mechanical performance is well suited to tensioning applications, making them commonly used at low‑voltage lines, on 10 kV tension poles and terminal poles, and at guy‑wire insulation points. Typically, they are installed in pairs to form a tension‑type insulator assembly. With their compact size and low cost, they are widely employed as auxiliary insulating components for tightening line terminations and anchoring jumpers.
25
2026
/
06
Pin-type insulators are equipped with integral mounting screws, allowing direct attachment to crossarms. Insulation installation can be completed simply by tying the conductors to the top of the insulator, making installation convenient and cost‑effective. They are primarily suited for 0.4 kV low‑voltage, 6 kV, and 10 kV distribution lines on straight poles and small angle poles. However, they cannot withstand high tensile loads, so they are generally not used independently on 35 kV and higher‑voltage lines. In China, they are widely employed in both urban and rural distribution networks.
25
2026
/
06
The line post insulator features an all‑solid construction with a multi‑layer shed design, mounted securely at the base of the flange. It exhibits excellent flexural strength and, compared to pin-type insulators, offers a longer creepage distance and superior resistance to pollution flashover. It is commonly used on straight-line and small‑angle poles in 10 kV and 35 kV distribution lines, and is well suited for replacing conventional pin‑type insulators during line upgrades in harsh polluted environments such as coastal areas with salt spray or regions affected by chemical dust, thereby significantly reducing leakage‑current‑induced tripping faults.
25
2026
/
06